POWERSIL® PASTE AP
Product information "POWERSIL® PASTE AP"
General Characteristics
1 30h / 200°C
2 30h / 200°C
3 150g cone / 5s penetration time
|
Property
|
Condition
|
Value
|
Method
|
|---|---|---|---|
| Appearance | - | opaque to whitish | - |
| Bleeding[1] | - | max. 4.0 % | FED-STD 791 M 321 |
| Density | 23 °C | 1.1 g/cm³ | DIN EN ISO 1183-1 A |
| Dielectric strength | - | 20 kV/mm | IEC 60243-1 |
| Dissipation factor | 50 Hz | 3 x 10⁻⁴ | IEC 62631-2-1 |
| Loss of weight[2] | - | max. 5.0 % | FED-STD 791 M 321 |
| Operating temperature | - | -40 - 200 °C | - |
| Penetration (unworked)[3] | - | 250 - 280 1/10mm | DIN ISO 2137 |
| Permittivity | 50 Hz | 3.7 | IEC 62631-2-1 |
| Solidifying point | - | approx. -45 °C | - |
2 30h / 200°C
3 150g cone / 5s penetration time
These figures are only intended as a guide and should not be used in preparing specifications.
Disclaimer
All the information provided is in accordance with the present state of our knowledge. Nonetheless, we disclaim any warranty or liability whatsoever and reserve the right, at any time, to effect technical alterations. The information provided, as well as the product's fitness for an intended application, should be checked by the buyer in preliminary trials. Contractual terms and conditions always take precedence. This disclaimer of warranty and liability also applies particularly in foreign countries with respect to third parties' rights.
Properties "POWERSIL® PASTE AP"
| Dielectric strength: | 20 kV/mm |
|---|---|
| Viscosity [mPa·s]: | 250,000 |